Hangars & large openings
Define leaves, loads, transmission, wind constraints and opening sequences before selection.
Our sectors · A selection by application
Aviation & airports
A site entrance, large hangar door or workshop requires a study based on actual uses and constraints.
Start with your installation.
The catalogue provides selection by use for industry and aviation. It distinguishes industrial perimeters from areas subject to specific rules and requires hangars to be sized from drawings.
Workshops & specific areas
Zone classification and documents for the exact model are required to assess a potential ATEX variant; a range does not qualify the entire installation.
No airport customer reference or overall site certification is claimed. The study concerns access points and closures, not onboard aircraft equipment.
Product information to prepare selection
p. 19FADINI
Industrial doors — MEC and FIBO LB
For sliding industrial doors or special configurations, selection depends on force and transmission. An aviation application…
FIBO 300 LB · FIBO 400 LB · …
View product page ↗3 entries
p. 46GfA ELEKTROMATEN
SI SG186F — Very large doors and shutters
A transmission and structural assessment is essential for large openings. For hangars and aviation buildings, attach…
SI 260.5 / SI 260.9 · SI 360.5 / SI 360.9 · …
View product page ↗3 entries
p. 50GfA ELEKTROMATEN
ST — Industrial sliding doors
For sliding building doors, consider pulling force and transmission. Weight, rails and wind influence selection.
ST 16.15 / ST 16.24 · ST 30.15 / ST 30.24 · …
View product page ↗3 entries
p. 51GfA ELEKTROMATEN
ST — Controls and large doors
A hangar door may have several leaves and opening priorities. Prepare a system overview before defining controls and…
ST 60.15 / ST 80.24 · TS 400 · …
View product page ↗3 entries
p. 52GfA ELEKTROMATEN
FT — Folding doors
Geared motors for folding doors. Define leaves, angles and joints; force depends on geometry throughout the…
FT 60.4 · FT 80.2 · …
View product page ↗3 entries
p. 53GfA ELEKTROMATEN
ATEX — SI with integrated safety brake
The Ex designation alone does not validate an installation. Provide gas/dust zone classification, group, temperature class and…
SI 25.15 Ex · SI 40.15 Ex · …
View product page ↗3 entries
p. 54GfA ELEKTROMATEN
ATEX — KE and SE
The KE and SE families suit different door architectures. Specify zone, motor, accessories, fall protection and…
KE 35.24 Ex / KE 80.12 Ex · KE 9.24 Ex · …
View product page ↗3 entries
p. 60GfA ELEKTROMATEN
TS-C — New generation of controls
Manufacturer note dated 6 March 2026: IP65, enclosure 175 × 390 × 90 mm and connected functions depending on software rollout. Confirm availability…
TS 91.11 • 20910110 · TS 92.12 • 20920120 · …
View product page ↗4 entries